VIA EPIA-M910 User Manual
36
3.2.
SATA DOM Power Jumper
The SATA connectors can be used to support Disk-on-Module flash drives. The power for SATA DOM is
controlled by the jumper labeled as “J1”. When the jumpers are set, +5V will be delivered to the 7
th
pin
of the SATA connectors. The jumper settings are shown below.
Figure 33: SATA DOM power jumper diagram
SATA1 Settings
Pin 2
Pin 4
Pin 6
DOM support
Short Short Open
Regular (default)
Open Short Short
SATA2 Settings
Pin 1
Pin 3
Pin 5
DOM support
Short Short Open
Regular (default)
Open Short Short
Table 32: SATA DOM power jumper settings
Summary of Contents for EPIA-M910
Page 107: ......