020574.06
31
vetus®
Installation instructions thruster RIM DRIVE 250 mm
7 .8 Configuring a panel for the steering position
where the panel is placed
1 x
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
1 Place the panel in configuration mode
• Press and hold the On / Off button for 10 seconds.
OR
Helm station
1
2
3
4
Helm station
1
2
3
4
1 BLUE, flashing
2 RED, flashing
3 BLUE, flashing
RED, quick flashing
4 BLUE and RED,
simultaneously flashing
2 Push the joystick to the right.
didahdi
( . − . )
3 Keep the joystick in this position and press
the On/Off button.
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
4 Release the joystick after the signal didahdi
( . – . ) is given.
5 Select the helm station where the panel is sited by pushing the joystick to the left or the right and then
releasing it. The colour and flashing of the LED indicates the number of the helm station.
6 Press the On/Off button once
to confirm the setting.
10 seconds
seconds
Configuration mode
seconds
6
dididididididid ( . . . . . . )
dididididah ( . . . . − )
4
2
3
4
5
6
1
Carry out the following actions on EACH panel in the order indi-
cated:
BPPPA
BPPJA
ON/OFF
ON/OFF
n
ote
With a bow and stern thruster panel, together at the same helm
station, the helm station number entered must be the same .
n
ote
Settings are retained even if the supply voltage is switched
off!
1
2
3
ENGLISH
