Vetus ELINE050, Installation Instructions And Operation Manual

Page: 30 / 44

30
370301.01 vetus®
Installation instructions and operation manual E-Line electric propulsion
didahdi ( . − . )
2 x
BLUE and RED,
simultaneously
flashing
RED BLUE
1 x
BLUE RED
1 x
If, during the test run, it appears that the movement of the boat is
opposite to the direction in which the lever is moved, this can be ad-
justed as follows.
Carry out the following actions on EACH panel in the order
indicated:
n
ote
Settings are retained when the power supply is switched off!
1 x
2
4
5
3
8 .8 Changing the thrust direction
1 Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
10 seconds
seconds
Configuration mode
seconds 6
dididididididid ( . . . . . . ) dididididah ( . . . . − )
4
1
2 Press the "ON / OFF" button twice. Now the panel is in configura-
tion mode.
3 The LED at the "ON/OFF" button will now simultaneously flash
blue and red and a continuous audible signal will be heard.
6 Press the 'ON/OFF' but-
ton once to confirm
the setting.
4 If the LED edge of the 'ON/OFF'
button is red: move the lever
once to the left. The LED edge
now turns blue and the thrust
direction has been changed.
5 When the LED edge of the 'ON/
OFF' button is blue: move the le-
ver once to the left. The LED edge
now turns red and the thrust di-
rection has been changed.
OR
6
Always perform the following 2 configurations
first: - whether the panel is to operate a port or
starboard motor (see 11 .6) and - at which helm position the panel is placed (see
11 .7) . Then change the thrust direction if necessary .
n
ote