12
370401.01
vetus®
Owner’s manual E-Line motor control lever ELPS
3 .6 Configure a panel to operate a port or star-
board E-Line motor
1 x
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "ON/OFF" button to turn the panel
to the OFF position.
2 Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
BLUE
RED
1 x
1 x
1 x
3 Press the 'ON/OFF' button to
confirm. Now the panel is in
configuration mode.
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
4 Configuring for a port side motor: Move the lever to the left once. The 'ON/OFF' button
LED lights up blue.
Configuring for starboard motor: Move the lever to the right once. The 'ON/OFF' button
LED lights up red.
5 Press the 'ON/OFF' button once to confirm
the setting.
10 seconds
seconds
Configuration mode
seconds
6
dididididididid ( . . . . . . )
dididididah ( . . . . − )
4
1
2
3
4
5
n
ote
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
n
ote
Settings are retained when the power supply is switched off!
2
1
n
ote
As delivered, the panel is configured for a port side motor .
1 Move the lever to the left.
ENGLISH
