WARNING!
Danger to life due to unsecured vehicle or moving components!
Uncontrolled movements of the vehicle or components can result in
serious injuries or even death due to the high dead weight.
Observe the following points at all times:
– Secure the carrier vehicle against inadvertently rolling off (e.g., with a
parking brake or by removing the key).
– Always use a suitable lifting device for heavy components.
– During the disassembly of the Smart
Fork
®
, ensure that loosened parts
do not fall down or tip over.
– Immediately place disassembled components to one side to prevent
them falling.
6.2.1
Daily visual inspection by the driver
Personnel:
n
Driver of industrial trucks
Protective equipment:
n
Protective work clothing
n
Industrial helmet
n
Protective gloves
n
Safety shoes
n
Check the Smart
Fork
®
applications for functionality.
Check the camera optics:
– The camera protective lens (ATEX polycarbonate lens) must not be covered, dirty,
clouded or damaged.
– The Smart
Fork
®
Front
Cam
application must be securely installed in the fork arm.
– The cables in the Smart
Fork
®
must be firmly adhered in place. Fill worn adhesive
solely with approved SikaTack-Drive adhesive and leave it to harden for at least 60
minutes.
n
Check the fork arm locking device for functionality:
– The Smart
Fork
®
must be engaged in the designated locking groove (Fig. 10/2).
– The Smart
Fork
®
lever must be fully engaged.
n
The Smart
Fork
®
must be free from dirt (including grease) and ice.
n
The Smart
Fork
®
hooks must not exhibit any signs of damage.
n
The Smart
Fork
®
must not exhibit any deformations, cracks, damage or sharp edges.
n
Check the strain relief for functionality:
– The connection cable must have enough play in every position and may not be
under tension or be trapped or kinked.
n
Check the connection cable for functionality:
– The plug connection for the camera cable must be plugged together securely.
– The cables must not have any damage, cracks or kinks.
Maintenance
Maintenance activities > Daily visual inspection by the driver
EN
SmartFork
®
FrontCam ATEX for use in the Ex zone - BVS 20 ATEX E 108 X
39
