User Instructions For
The USB- 802 Series "MegaSwitch"
Keyboard, Mouse, Audio and Multiple Video Switches
Congratulations on your purchase of a VETRA USB MegaSwitch! This quality product is designed and built by us
in the USA and is backed by a VETRA Three-year Warranty and unlimited free technical support. We invite your
comments, please email us at
or call us at the numbers given at the end.
INTRODUCTION
The USB-802 "MegaSwitch"
Keyboard, Mouse, Audio and Multiple Video Switches are full function, Integrated
Switches with keyboard control (hot-key) selection, switching keyboard, mouse, and video. Models are also available for
switching audio and multiple video outputs. The "MegaSwitch" allows one Workstation comprised of a USB Keyboard, USB
Mouse, and VGA Monitor(s) to control and work with up to two PC's. All models come with the VIP-210 power supply.
The "MegaSwitch" system consists of the following components:
1. One - Switch Unit;
2. One – Power Supply.
Note: The "MegaSwitch does not come with USB, Audio, or Video extension cables.
They may be ordered from
Vetra separately.
INSTALLATION
Before connecting PC's to the Switch, make sure that the Switch is powered by its Power Supply!
The PC's may be powered or not when you connect them to the Switch.
Keyboard, mouse and video monitor may be connected to the Switch at any time.
Do not power down the Switch while any PC is connected to the Switch!
There are three main steps to connect the Switch:
1. Connect PC's to Switch unit:
USB
Connect any available USB input on the PC's to the Switch using USB A-B cables. Connect PC #1's USB port to the
backpanel connector of the Switch marked "PC1". Connect PC's #2 USB port to the back panel connector of the Switch
marked "PC2". It is not necessary to have both PC's connected for the Switch to operate.
Video
Connect the Video outputs of the PC's to the Switch using 15 pin HDD15 male/female extension cables. Connect PC #1's
video output to the backpanel connector of the Switch marked "TO PC1 MON". Connect PC’s #2 video output to the back
panel connector of the Switch marked "TO PC2 MON".
For the V2, V3, and V4 series MegaSwitch:
Connect PC #1’s Monitor A video output to the back panel connector of the Switch marked “PC1 MON A” and connect PC#1’s
Monitor B video output to the back panel connector of the Switch marked “PC1 MON B”. Repeat for PC #2.
For V3 and V4 series of MegaSwitch connect PC#1’s Monitors C and D video outputs to the back panel connectors of the
Switch marked “PC 1 MON C” and “PC1 MON D”. Repeat this step for PC #2.
275 Marcus Blvd, Ste-J, Hauppauge, NY 11788-2022 USA
Tel: 631.434.3185 Fax: 631.434.3516
www.vetra.com email: [email protected]
