User Instructions for
VIP- 804-KMV-TS Series "MegaTouch"
Keyboard, Mouse, Video and Serial Touch Screen Switch
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
CE
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology
Equipment type and for the Commercial Light Industrial equipment class.
INTRODUCTION
The VIP-804-KMV-TS "MegaTouch"
Keyboard, Mouse, Video and Serial Touch Screen Switches are available as a full
function, Integrated Switch with keyboard control selection, switching keyboard, mouse, video and serial touch screen. The
"MegaTouch" allows one Workstation comprised of a PC Keyboard, a PS/2 Mouse, and VGA Monitor with serial touch screen
capability to control and work with one or up to four PC's.
Note: The "MegaTouch” does not come with keyboard, mouse, VGA or serial extension cables.
They may be
ordered from Vetra separately.
INSTALLATION
There are two main steps to connect the Switch:
1. Connect PC's to Switch unit:
a) Keyboard
Connect the keyboard inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect
PC#1's keyboard port to the backpanel connector of the Switch marked "PC1 KBD". Connect PC’s #2, #3, and #4 keyboard
port’s to the appropriate backpanel connectors of the Switch marked "PC2 KBD", “PC3 KBD” and “PC4 KBD”.
b) Mouse
Connect the mouse inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect PC#1's
mouse port to the backpanel connector of the Switch marked "PC1 MSE". Connect PC’s #2, #3, and #4 mouse port’s to the
appropriate backpanel connector of the Switch marked "PC2 MSE", “PC3 MSE”, and “PC4 MSE”.
c) VGA Video
Connect the Video outputs of the PC's to the Switch using 15 pin HDD15 male/female extension cables.
Connect PC#1's video output to the backpanel connector of the Switch marked "TO PC1 VIDEO". Connect PC’s #2, #3, and
#4 video output’s to the appropriate backpanel connector of the Switch marked "TO PC2 VIDEO", TO PC3 VIDEO”, and “TO
PC4 VIDEO”.
Or in the case of the V2 series MegaSwitch
Connect PC#1’s Monitor A video output to the backpanel connector of the Switch marked “PC1 MON A” and connect
PC#1’s Monitor B video output to the backpanel connector of the Switch marked “PC1 MON B”. Repeat this step for PC #2,
#3, and #4.
d) Serial Touch Screen
Connect the Touch Screen inputs of the PC's to the Switch using 9 pin DB9 male/female extension
cables. Connect PC#1's touch screen input to the backpanel connector of the Switch marked "TO PC1 T.S.". Connect PC’s
#2, #3, and #4 touch screen inputs to the appropriate backpanel connector of the Switch marked "TO PC2 T.S.", TO PC3
275 Marcus Blvd. Ste-J, Hauppauge, NY 11788-2022 USA
Tel: 631.434.3185 Fax: 631.434.3516
www.vetra.com email: [email protected]
