5
OPERATION INSTRUCTIONS CONT’D
•
If desired, the jib arm can be extended outward to pick up loads farther from the jib pole. Pull the pin from the
middle of the jib arm, grasp the end of the inner jib arm section, and pull outward.
Warning: Only lift loads that are directly below the hook. Do not use the lifting jib in any application that will create side-
loading of the cable or the jib arm. Never use the jib to pull or drag loads.
Warning: Do not attempt to move the inner jib arm in or out when a load is hanging on the load hook.
Note: Lower the load hook before attempting to pull the inner jib arm out.
Caution: Verify that the securing pin is fully inserted through the jib arm before lifting a load to prevent the telescoping
section from sliding unexpectedly during use.
•
Tighten the rotation locking bolt to prevent the load from swinging as it is raised.
•
Lower the load hook, and secure the load’s rigging to the load hook.
Warning: The load hook’s safety latch must be closed before lifting a load.
•
Press the “UP” button to raise the load.
Note: Keep one hand on the underside of the jib arm to steady it as the load is raised.
Caution: Watch the load and the jib arm for signs of excessive loading as the load is raised.
•
If necessary, loosen the rotation locking bolt and swing the load to the desired location, then press the “DOWN”
button to lower it.
Caution: Ensure that the load is stable before releasing the rigging from the load hook.
•
Stow the lifting jib with the inner jib arm completely retracted and securely pinned, and lowered so that it is
parallel with the jib mast. With the load hook sufficiently below the end of the jib arm pulley:
(WTJ-E) unpin the jib arm at the end of the jib arm support, or;
(WTJ) if necessary, adjust the jib arm to the lowest hole in the front of the jib head. Unpin the jib arm at the
rear of the jib head and lower it until it is lowered and parallel to the mast.
•
Secure the jib arm against movement:
(WTJ-E) repin the end of the jib arm support at the bracket located about halfway up the jib arm, or;
(WTJ) replace the pin in the center hole at the front of the jib head.
Caution: The jib arm must be folded down and secured alongside the jib mast before moving the vehicle to which it is
mounted. Never move the vehicle while a load is suspended from the lifting jib!
Caution: The electric motors are designed for intermittent duty. Extended use without cooling will cause overheating
which can damage the motor. The maximum continuous run time is three minutes. Monitor the motor temperature
whenever the winch is being operated frequently.
Note: Consult and read the winch owner’s manual for details regarding the winch’s operation, maintenance, and
servicing requirements.
Ensure that all safety and warning labels stay in place and are legible. Refer to the labels page in this manual.
E
N
G
L
I
S
H
