HT-10-2036A ASSEMBLY INSTRUCTIONS
BASIC DATA:
MODEL CAPACITY
LOWERED
HEIGHT
RAISED
HEIGHT
TABLE
DIMENSIONS
NET
WEIGHT
HT-10-2036A 1,00LBS.
36”
54”
20” X 36”
187 LBS.
ASSEMBLY INSTRUCTIONS:
1.
Put the frame on the ground, install outer guide posts (#15), and
secure them by M8 bolt (#17), flat washer (#18) and lock nut
(#20).
2.
Install hydraulic cylinder on the frame, and secure it with big
washer (#49), spring washer (#50) and M12 bolt (#51).
3.
Remove solid plug on top end of the cylinder and replace it with
bleeder (vent) plug
to allow air to be bled from the hydraulic
system
.
4.
Lift up the cylinder to ½” height, join the cylinder joint block
(#6) to the lift piston (#(7), and secure them by nut (# 7).
5.
Use spanner to tighten nut (#7) under the table.
6.
Install inner guide posts (#11) and secure them with M8 bolt
(#14), spring washer (#13) and flat washer (#12).
7.
Install push/pull handle (#1) on front side of the table (#5), and
secure it with M8 bolt (#4), spring washer (#3) and flat washer
(#2).
8.
Adjust the verticality of inner guide post (#11) and outer guide
post (#15) with the help of M8 bolt (#16).
9.
Now tighten all bolts & nuts.
10.
Check all the parts, and then test this lift table with weight
and without weight.
