Operator’s Manual
2/2/21
EHLT, MANUAL.DOCX
Copyright 2020, Vestil Manufacturing Corp.
Page
9
of
24
ELECTRICAL AND HYDRAULIC SYSTEM DIAGRAMS
Care should be taken to identify all potential hazards and comply with applicable safety procedures
before beginning work. Ensure that all system pressure and electrical power have been removed
before attempting to work on the electrical or hydraulic systems. Follow all applicable lockout/tagout
procedures.
The load must be removed, and the platform either positively and adequately supported or fully
lowered, before any work is performed on the lift table.
Only qualified individuals trained to understand mechanical devices and their associated electrical and hydraulic
circuits, as well as the hazards associated with them, should attempt troubleshooting and repair of this equipment.
115 VAC, Single-Phase Electric Circuit Diagram (24124012 Rev. B)
Note: Overcurrent & short circuit protection and disconnect must be provided by end user.
* Number of toe guard switches can vary according to size.
