Operator’s Manual
2/2/21
EHLT, MANUAL.DOCX
Copyright 2020, Vestil Manufacturing Corp.
Page
3
of
24
The lift table shall be installed only by trained and qualified personnel with access to appropriate equipment.
Electrical connections shall be performed by a qualified electrician.
DO NOT load the table beyond its lift rated capacity. Handle only stable and safely arranged loads within the
maximum capacity of the lift. The lift capacity can be found on the nameplate on the hinged end of the platform.
ALWAYS use care to center and distribute the load evenly on the lift platform.
DO NOT attempt to lift an overhanging or cantilever load.
DO watch the load when the lift table is in operation.
ALWAYS keep clear of the lift table while it is moving.
DO NOT place hands or feet under the platform. DO NOT put any body part in the scissor mechanism.
DO NOT use this lift table to raise personnel.
DO NOT store objects under the platform.
DO NOT use the lift table if any damage is observed, or unusual noises heard.
DO NOT operate a lift table with its perimeter toe guard removed, disabled, or inoperable. An optional
accordion skirt may be installed in above-ground installations.
DO ensure that all information, safety, and warning labels remain in place and are legible.
DO remove any load from the lift table before servicing the lift table or its hydraulic power unit. DO completely
lower the platform, or use the attached maintenance prop bars to support the platform, before servicing this
product.
If oil is needed, DO use an anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F (ISO 32 cSt @ 40°C)
or Dexron non-synthetic transmission fluid. DO NOT use brake fluid or jack oils in the hydraulic system.
Contact the manufacturer for SDS (Safety Data Sheet) information.
Maintenance and repairs are to be done only by personnel qualified to perform the required work.
Consideration will not be given for warranty repair charges without prior written authorization by the
manufacturer.
DO NOT perform any modifications to the lift table without the manufacturer’s approval. Failure to receive
authorization for changes to the equipment automatically voids the warranty.
Proper use and maintenance are essential for this product to function properly.
Always use this product in accordance with the instructions in this manual.
Periodically lubricate pivot points with bearing grease.
Keep the product dry and clean at all times. Always use this product indoors.
Use only factory-approved replacement parts. Contact Vestil Manufacturing to order replacement or spare
parts.
Contact the manufacturer for SDS information.
MODEL NUMBER AND CAPACITY
The lift table model number, serial number and capacities are printed on the nameplate, found on the hinged side of
the platform. Refer to the product catalog of the factory for further information. Include the model and serial numbers
in all correspondence with your dealer or the factory.
The load capacity rating as printed on the nameplate of your lift table designates its net capacity. The addition of
ancillary equipment to the lift table will necessitate a lowering of the load capacity. The lift table’s load capacity must
never be exceeded, as permanent damage or personal injury may result.
