8/7/2019
ALL-T-2/4-GPT MANUAL
Copyright 2019 Vestil Manufacturing Corp.
Page 7 of 26
PARKING BRAKE:
This product is equipped with a parking brake. This brake should only be applied when the unit is stopped. Do not
use the parking brake to slow the unit.
1. To apply the brake pull the brake lever up until it locks.
2. To release the brake, push the lever downward.
NOTE:
ONLY park the mover on
level
ground.
Unload the hydraulic system when you are finished using the truck by lowering the
carriage all the way.
DISENGAGING THE TRANSMISSION (NEUTRAL MODE):
The unit can be moved manually by putting the transmission into neutral.
This decouples the drive wheels from the transaxle. To put the transmission
into neutral:
1. Locate the transaxle release lever.
2. Push the lever in and down until it seats inside the release bracket.
To put the transmission back into drive mode, lift the lever and pull it towards you.
RECORD OF SATISFACTORY CONDITION:
Before using the product for the first time, make a record of its appearance and functions. Cycle the
carriage/forks up and down. Describe the motion (e.g. smooth and at a uniform rate). Drive the unit in forward and
in reverse. Describe the motion. Thoroughly photograph the unit from multiple angles including all labeling applied
to it. Each feature listed in
Inspect the following
components (below) should be photographed in detail. Describe
where each label is located. Collate all photographs and writings into a file. Mark the file appropriately to identify it.
This record documents the truck in satisfactory condition
. Compare the results of all inspections to this record
to determine if the unit is in satisfactory condition. Do not use it unless it is in satisfactory condition. Purely cosmetic
changes, like damaged paint/powder coat do not constitute changes from normal condition. However, touchup paint
should be applied to all affected areas as soon as damage occurs. Contact
appears on the cover page) if you have questions that are not addressed in these instructions.
INSPECTIONS AND MAINTENANCE
Proper maintenance is essential to keep this product in satisfactory condition and to maximize the
service life of the unit.
o
DO NOT fill the hydraulic system with brake fluid or jack oils. Only use anti-wear hydraulic oil, viscosity grade
150 SUS at 100°F (ISO 32cSt at 40°C) or Dexron transmission fluid.
o
Fill the engine with oil and gasoline as instructed in the manufacturer’s manual. Perform maintenance on the
engine as directed in that manual.
Inspect the following components:
1. Motor: Maintain the motor as instructed in the manufacturer’s manual. The manual is provided with the unit.
Parking brake lever
Transaxle release lever
Drive mode: axle engaged
Neutral mode: axle
disengaged
