Vessel Stat-Clean C-100, Instruction Manual

Page: 27 / 40

27
■
Functions of parts
Functions of parts
Be sure to understand the functions of the parts to ensure safe operation and work.
Power supply terminal Power supply terminal 24 VDC ± 5% [RJ45]
RMS terminal Data communication terminal used when building RMS [RJ45]
Interface terminal Alarm signal output and remote control signal input terminal [RJ45]
Dip switch
H.V. High voltage error setting (Auto Power-off/ Continue to run)
A/BAL Auto balance mode setting (ON / OFF)
TIP/C Tip cleaning timer setting (ON / OFF)
Display
Shows the operation status and settings (Ex. frequency, pulse ratio,
operation status).
Infrared light receiver Receives infrared light from the remote controller.
Ion balance indicator Lights according to the polarity of the charge at Auto balance mode.
SET button
Sets the frequency, pulse ratio, output voltage, address and tip
cleaning timer.
UP button Increases the value displayed.
DOWN button Decreases the value displayed.
TX/RX lamp
Blinks when the RMS function is in use and lights when the ion bar
is remotely controlled.
TIP/C lamp Lights when set time for tip cleaning is up and AL-2 displayed.
H.V. lamp Lights when a high voltage error is detected and AL-1 displayed.
POSI lamp Lights during normal positive high-voltage operation.
NEGA lamp Lights during normal negative high-voltage operation.
Remote controller Changes the frequency and pulse ratio for the set address.