Vescent SLICE-DHV, Quick Start Manual

Page: 18 / 20

Last update: 2021/08/26 14:26 slice:dhv https://www.vescent.com/manuals/doku.php?id=slice:dhv
https://www.vescent.com/manuals/ Printed on 2021/08/30 08:42
Fig. 25: Trigger In controls both CH 1 and CH 2
Output Trigger
A TTL trigger output in sync with either of the internal ramps can be obtained at the Trigger Out
(bubble 7,
figure 3 ). Touch the I/O icon on the control bar to see the I/O screen ( figure 22 ). Touch the
blue field labeled Trigger Out for the selection screen in figure 26 and select the ramp from which
channel the trigger out signal shall be derived. The end of the ramp is in sync with the falling edge of
the trigger.
Only a single Channel may be chosen for outputting a trigger at any given time.
Fig. 26: Trigger Out is in sync with CH 2 ramp s
System Settings
Touching the System Settings button on the Control Bar (figure 9 ) will open the System Settings
screen as seen in figure 27 .