Installation 3
VES, LLC
Elite-RS Panel Installation Manual
VF3529-00, Revision E01.03
H-Series
19 of 146
Anchoring the Cabinet
Drill holes in the premises-wall to anchor the empty Elite-RS cabinet using mounting-hardware to secure it.
Feeding Cable
Remove knockout tabs from the cabinet to feed cabling for AC power, 24 VDC, TELCO, eNet, VESNet,
addressable devices, initiation devices and notification appliances. Dress AC cabling as far away as possible from
TELCO, and device communication.
Separate high and low voltage wiring in the enclosure with a minimum gap of 0.25". Reference UL 864 12.3.1.
To feed cabling into the cabinet:
Replacing Cabinet Components
Replace cabinet components of the Elite-RS to prepare for wiring the terminal-connector for AC power.
To prepare for wiring the terminal-connector for AC power:
1
Remove the top-left and top-right knockout tabs from the cabinet.
Figure 3-9
Removing Knockout Tabs
2
Feed the AC power-cable into the top-left-hole provided from the knockout-tab.
3
Feed cables for 24 VDC, TELCO, VESNet, addressable devices, initiation devices and notification
appliances into the top-right-hole. Remove additional knockout-holes directly adjacent to this knockout-hole, to
provide more cabling space as required.
1
Remove debris from the base of the cabinet that may have accumulated during the anchoring process.
2
Replace the front-panel on the cabinet-hinges and insert the hinge-pins to secure it.
3
Replace the cabinet-door on the cabinet-hinges and insert the hinge-pins to secure it.
1
2
3
4
Key
Description
1
Remove this tab to feed the
AC power-cable.
2
Remove this tab to feed cables for
TELCO, VESNet and device com-
munication.
3
Top-rear of the Elite-RS Panel.
4
Top-front of the Elite-RS Panel.
Front-panel door flange shown.
CAUTION!
Avoid routing SLC cabling through the same conduit as AC lines.
