Vertiv
|
NetSure™ SCC Controller User Manual (UM1M520HNA)
|
Rev. H
27
WEB INTERFACE MENUS
Overview
This section provides descriptions of the WEB Interface Menus. Refer also to “Using the WEB Interface” on
page 20.
Homepage
In the Web Interface, after entering a valid
User Name
and
Password
and clicking
OK
, the "Homepage" window
opens. See also “Logging into the Controller” on page 23.
Figure 3:
Web Interface Homepage
Setting Static IP, SNMP Community Strings, and DHCP Communications Parameters
From the Homepage, you can set Static IP, SNMP Community Strings, and DHCP communications parameters.
a)
Set the controller for DHCP Enabled if the controller is to be connected to a network with a DHCP
server. The DHCP server assigns an IP address to the controller.
b)
Set the controller for DHCP Disabled if the controller is to be connected to a network or local computer
with a static IP address. Also set the IP Address, SubNet Mask, and Gateway parameters for the
controller.
Summary of Contents for NetSure SCC
Page 8: ...Vertiv NetSure SCC Controller User Manual UM1M520HNA Rev H 8 This page is intentionally blank...
Page 35: ...Vertiv NetSure SCC Controller User Manual UM1M520HNA Rev H 35 This page is intentionally blank...
Page 36: ...Vertiv com Vertiv Headquarters 1050 Dearborn Drive Columbus OH 43085 USA UM1M520HNA RH 10 19...
