Vertiv Liqui-tect LP6000, Installer/User Manual

Page: 39 / 82

Troubleshooting Controller Using Set Cable Relay
Set Cable Relay simulates 8060 ohms of leak-detection cable for a period up to 5 minutes.
To test controller operation:
1. Click
Configuration
>
Leak Settings
.
Leak Settings on page 37 opens.
2. Click
Set Cable Relay
, then click
Home
.
3. On the Liqui-tect Home Page, confirm proper function by verifying that the displayed values
match those listed for the fields that follow:
• Cable Length = approximately 2015 ft
• Leg 1 Resistance = approximately 8060 ohms
• Leg 2 Resistance = approximately 8060 ohms
5.3.2 Virtual Zone Settings
Virtual Zone Configuration defines the virtual zones in your installation.
FIELD DESCRIPTION
Zone # Number designating a zone.
Label Descriptive label for the zone displayed in notifications and event logs. 30-character limit.
End Distance
Distance on the leak-detection cable at the end of the zone. Zone #1 always starts at 0 (zero), and the end of zone 1
is designated by distance from start. The each subsequent zone starts at the End Distance of the previous zone.
Table 7.3 Virtual Zone Configuration fields and options
5.3.3 Slave Controller Settings
The LP6000 can act as a Modbus or BACnet IP master for up to 127 Liqui-tect devices connected to the
system. See
Modbus Communication Protocol on page 61, to configure the Liqui-tect as a Modbus master.
FIELD DESCRIPTION
Controller Number designating the controller.
Label Descriptive label for the controller. 30-character limit.
Control Type
Selects the type of slave device. Options are:
•
Distance Read
Enable Comm Type Type of communication used by slaved device.
Address/Slave ID/Device ID Address for slaved devices.
IP Address IP address for the slaved device.
Table 7.4 Modbus/Slave Controller/Zone Configuration fields and options
Vertiv | Liqui-tect LP6000 Installer/User Guide | 39