Vertical WAVE IP 2500, Installation Manual

Page: 78 / 236

Installing expansion components 4
-
16
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Installing EXUs on a Wave IP 2500 Server
You can install up to 4 EXUs on a Wave IP 2500 Server. EXU’s cannot be wall-mounted.
To install an EXU:
1. Unplug the Wave IP 2500 Server’s power cord, but do not disconnect the grounding wire.
2. Remove the connector hatch retention screws on the top of the Wave Server base unit,
and then remove the connector hatch.
3. Remove the backplane terminator from the base unit using both hands to pull it straight
up and out.
Caution:
Make a note of the direction that the backplane terminator is facing when you
remove so that you can replace it the same way. A reversed backplane terminator can cause
malfunctions and damage equipment.
4. Open the side and rear latches on the EXU.
5. Stack the EXU on top of the base unit or another EXU, aligning pins and electrical
connectors on the bottom of the EXU with the pins on the lower unit.
6. Press down gently to engage the backplane connector.
7. Engage the side and rear latches to secure the EXU.
8. If the base unit is rack-mounted, attach the EXU using 2 rack screws per side. If this is the
top-most EXU, go to step 10.
Release 4.0 June 20, 2013