Vertical TeleVantage 7.5, Install Manual

Page: 84 / 180

7-12 I
NSTALLING
I
NTEL
T
ELEPHONY
C
OMPONENTS
2.
The Intel Dialogic GlobalCall 4.3 installation program starts.
Follow the on-screen instructions.
Configuring the Intel Dialogic drivers ________________________
After the Intel Dialogic drivers and driver updates are installed, you must configure them for use
with the specific Intel Dialogic boards you are using. Intel Dialogic drivers must be configured
correctly before you can start the TeleVantage Server. (You do not need to configure drivers for
MSI/x analog station boards.)
After configuring your boards according to the instructions in this section, write down all of
your non-default configuration settings. If at any time you need to run the Restore Device
Defaults command in the Intel Dialogic Configuration Manager (DCM) in order to fix an Intel
Dialogic problem, you will lose all non-default configuration settings for all boards, and will
need to reconfigure them.
Important:
When the TeleVantage Server starts, it automatically starts the Intel Dialogic
drivers. Do not set the Intel Dialogic drivers to autostart in DCM. If the drivers are already running
when the TeleVantage Server starts, the Windows Service Control Manager may experience
problems.
Note that the following boards do not appear in DCM:
Q
Intel Dialogic DSIx digital station boards appear in the Intel MEA Configuration
program (described in “Configuring digital station boards” on page 7-29.)
Q
Toshiba Strata CS_DKTU station boards appear in the Windows Device Manager under
System Devices and are identified as
CTS:PCDKSC
.