Vertical Comdial DX-80, Technical Manual

Page: 25 / 322

- 25 -
DX-80 Programming Manual
O
VERVIEW
> P
ROGRAMMING A
N
EW
S
YSTEM
21. Enable/disable the TSI connection.
22. Enable/disable the conference tone.
23. Specify the call duration.
24. Specify caller ID codes and establish the local area code.
25. Enable/disable tenant calling per tenant group.
26. Enable/disable SMDR call output.
27. Program the voice mail
28. Set the Fax ring time.
29. Set the pre-defined call forward time.
30. Program the recognition time interval.
31. Set the conference talk time intervals.
32. Set the hold abandon time interval.
33. Set the unsupervised talk time.
34. Program the auto attendant.
35. Set the DISA access.
Details on how to perform these tasks are included in Section 6, Programming Call Handling . The DX-80 pro-
vides programmable features that allow you to establish these various settings.
1.3.4 SETTING UP TOLL RESTRICTIONS
Toll restrictions allow you to place restrictions on outbound toll calls, per tenant group and account code. Perform
the following steps.
1. Set up the Class of Services.
2. Set up the digit interval from 1 to 100, per tenant group.
3. Assign the account code length.
4. Program the account code passwords, from 1 to 600 as necessary.
Details on how to perform these tasks are included in Section 7, Programming Toll Restrictions . The DX-80 pro-
vides programmable features that allow you to establish these various settings.
1.3.5 SETTING UP UCD GROUPS
Uniform Call Distribution (UCD) groups allow you to link extensions for call handling. To set up the UCD groups,
perform the following steps for each UCD group (maximum of 24).
1. Assign the tenant group for this UCD.
2. Select the UCD attribute (UCD or VA).
3. Assign the UCD group member numbers 1 through 24 as applicable.
4. Select the hunt method you want to use for this UCD group.
5. Specify the no answer time.
6. Set up the timer and destination for overflow 1.
7. Set up the timer and destination for overflow 2.
8. Specify the overflow count.