Vertical comdial DX-120, Installation And Maintenance Manual

Page: 96 / 146

A
CCESSING
PC-DBA M
AINTENANCE
DX-120 Installation and Maintenance Manual
- 90 -
Configuration (continued)
3)
EXAMPLE
4) Click the X in the top right corner of each window to close it.
D
IAGNOSTICS
•
The Diagnostics submenu allows you to do any of the following:
• Run a Self Test for:
-
The System (with an option to wait for a report)
-
Board (s)
-
Port (s)
• Run a Report on a Self Test already performed on the system
•
The Diagnostics function can be invoked to force a diagnostic test operation.
•
The system performs this test automatically at the time it boots up (initial installation) and whenever
programmed to do so.
•
By default, the factory settings for the system Self-Test Time is set to “NULL” (never performed). (For
programming details, refer to the DX-120 Technical Manual, Volume II, Programming .)
•
The Diagnostic Self-Test can be invoked automatically via programming settings or manually.
•
When the Diagnostic Self-Test is invoked, the DX-120 performs a list of software and hardware checks to
assure proper operation of the hardware installed.
•
Diagnostic Test activity has the lowest priority in CPU processing tasks, therefore, the time required to
complete this testing operation could vary from one test to the next. When an automatic test or manual test
of the entire system is invoked, the testing time can take approximately 30 minutes.
•
Manual diagnostics testing can be invoked for the entire system or for one module or module port. To do a
manual test, perform the following steps.
Diagnositics (continued on next page)
Click the X at the top
right of each screen
to close them.
Click any of the
buttons to display
configuration
information for each
of the
corresponding
boards.
Each time you click a
button, configuration
information for the
corresponding board
appears in a second
window like this one.