Making Calls
2
-
11
Basic Operation
Wave Phone User Guide
If You Hear the Double Beep
You can press
#
to use the contact’s associated account code.
or,
You can enter a different account code, then press
#
.
If you enter the wrong account code, press
Flash
before pressing
#
and the system will let
you re-enter it.
Depending on how your Wave System Administrator configured your system, the prompt
may occur either after you dial the access code or after you dial the phone number.
If the prompt occurs after you dial the access code, enter the account code followed by
#
,
and then continue entering the phone number.
Example:
You would dial 9 [listen for the prompt]
8812 # 212 123 4567
(where 9 is the access code
and 8812 is the account code, and the numbers after # are the area code and phone number).
Disabling Call Waiting for a Call
Disabling call waiting is useful if you are using your extension to send faxes or to connect to the
Internet. In both cases, a call waiting tone disrupts the data flow.
To Disable Call Waiting for a Call
Press *70
and dial the number.
You do not hear the call waiting tone during that call. Incoming calls while you are on
that call are sent directly to your voicemail. After the call ends, call waiting is enabled
again.
Note:
You can enter *70 as part of a fax dial string to avoid the fax being disrupted by a
call waiting tone. For example, your fax dial string might be *70 9 1 617 555 7744.
Placing Calls through Wave from a Remote Phone
If you have permission, you can place outbound calls through Wave after logging on. These calls
are billed to Wave, give you access to the call-handling telephone commands, and are logged in
your Call Log.
To place a call through Wave from a remote phone:
1.
Log into your account (see “Logging In To Your Account” on page 2-1).
2.
Press
#
.
You will hear a dial tone.
3.
Dial an extension or an outside number (including access code).
Wave 4.0
June 2013
