7
Installation of the SU-1
1. Make sure that the transceiver is off. Remove the hard
or soft case, if used.
2. Remove the two screws affixing the belt clip and re-
move the belt clip, then remove the battery pack.
3. Locate the connector for the
SU-1
under the “Cau-
tion” label in the battery compartment on the back of
the radio, just carefully peel off the “Caution” label.
4. Remove the small Rubber Cushion from the “Cau-
tion” label. Keep this Rubber Cushion for future use,
because this Rubber Cushion must be replaced on the
connector board of the transceiver if you remove the
SU-1
from the transceiver. We recommend that this
Rubber Cushion be put on the bottom of the
SU-1
.
5. Align the connector on the
SU-1
with the transceiver’s
connector and gently press the unit into place.
6. Affix the “Caution” label, and replace the battery and
the belt clip.
7. Installation is now complete.
Important Note
The Barometric pressure/Altitude feature of the op-
tional
SU-1
are designed to be supplemental aids
for the information of the user, and are not intend-
ed to be a substitute for accurate, calibrated Ba-
rometer or Altimeter devices used for navigation
critical to personal safety.
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
Peel off the CAUTION Label
Press the
SU-1
Connector
Affix the CAUTION Label
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
CAUTION
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
CAUTION
