Interfaces and Connectors
EBX-11 Reference manual
37
CompactFlash
Connector J11 provides a socket for a Type I or Type II CompactFlash (CF) module. This IDE
based interface operates on the same channel than the IDE interface at connector J12. The CF
interface supports operation in DMA mode.
The following CF modules have been tested and qualified as bootable devices by VersaLogic.
Part numbers with a suffix of -3500 are RoHS-compliant.
Table 16. Qualified Bootable CF Modules
Manufacturer
Density
Mfg Part Number
Hagiwara
1 GB
CF1-1GMDG(H00AA)
Hagiwara
512 MB
CF1-512MDG(H00AA)
Silicon Systems
128 MB
SSD-C12M-3012
Silicon Systems
128 MB
SSD-C12M-3500
Silicon Systems
256 MB
SSD-C25M-3012
Silicon Systems
256 MB
SSD-C25MI-3012
Silicon Systems
256 MB
SSD-C25M-3500
Silicon Systems
256 MB
SSD-C25MI-3500
Silicon Systems
512 MB
SSD-C51M-3012
Silicon Systems
512 MB
SSD-C51MI-3012
Silicon Systems
512 MB
SSD-C51M-3500
Silicon Systems
512 MB
SSD-C51MI-3500
Silicon Systems
1 GB
SSD-C01G-3012
Silicon Systems
1 GB
SSD-C01G-3500
Silicon Systems
2 GB
SSD-C02G-3012
Silicon Systems
2 GB
SSD-C02GI-3012
Silicon Systems
2 GB
SSD-C02G-3500
Silicon Systems
4 GB
SSD-C04GI-3012
I
NSTALLING AN
O
PERATING
S
YSTEM ON
C
OMPACT
F
LASH
On EBX-11 Rev. 5.02 and earlier boards, to install an operating system from a CD-ROM drive to
the CF, the CF must be configured as the slave IDE device and the CD-ROM drive as the master.
To ensure proper OS installation, do the following:
1.
Verify that no jumper is installed at V2[1-2]. This is the default setting, which designates
the CF as the slave IDE device.
2.
Jumper the CD-ROM drive as the master IDE device.
3.
Configure the following CMOS Setup parameters on the Basic CMOS Configuration
screen:
DRIVE ASSIGNMENT ORDER | DRIVE C: Ide 1/Pri Slave
ATA DRV ASSIGNMENT | Ide 0: 5 = IDE CDROM
ATA DRV ASSIGNMENT | Ide 1: 3 = AUTOCONFIG,LBA
BOOT ORDER | Boot 1st: CDROM
StockCheck.com
