Vernacare Compact Plus Technical Manual-
Revision 2-Issued by N.Shields 14.2.2020
Page | 14
4.2.
Using the Wall Bracket Assembly
In some circumstances it is not possible to secure the machine to the floor. This could be
due to underfloor heating etc. In this instance a wall bracket assembly will be required to
ensure the machine will remain safe during operation. It also limits the vibration experienced
during the cycle. Below are instructions for fitting the wall bracket assembly:
Fit the mounting bracket to the back of the machine as shown.
The hex head screw which secures the retaining bracket to the
wall bracket only needs to be loosely fitted at this stage .
150mm
1
2
3
4
Mark the top of the bracket onto the fixing wall. The hex head
screw can now be removed and set aside.
Secure the wall bracket to the fixing wall in the previously
marked position. This must be done so using the appropriate
M8 fastener depending on location and wall strength.
The machine can now be placed up to the bracket. The
retaining bracket and hex head can now be secured . This
bracket assembly stands the machine a recommended 50mm
clear of the wall to allow for access.
Summary of Contents for COMPACT+
Page 1: ......
