19
07/20
7101-802G
Flue Collar
Stove Pipe/Liner
Gasket
Figure 5.3
B. Securing Stove Pipe/Liner to Flue Collar
1. There are 4 already drilled holes in the flue collar 90
degrees apart. Attach the flue collar to the stove pipe/
liner. If the seal is questionable use high temperature
sealant such as stove mastic
(Figure 5.3)
.
2. Attach gasket to bottom side of flue collar with a thin coat
of silicone.
C. Optional Offset Adapter
Optional use of a Simpson Duravent 15° Universal Elbow
Part Number 4615 may be purchased directly through your
local Simpson Duravent Pipe Distributor or from your local
Vermont Castings dealer, Part Number DV-6DLR-E15ADSS.
Figure 5.4
shows a vertical installation and also how to
create an optional 30° elbow installation.
The 15° elbow may be secured directly to the flue collar.
Follow the pipe manufacturer’s instructions for using
screws or rivets for attachment. Most pipe manufacturer’s
6 inch (152mm) diameter flue liners may be attached directly
to the top of the 15° elbow.
30 degree
30°
Vertical
Figure 5.4
5/16 Nuts
Attachment
Bar
5/16 Bolts
Figure 5.5
D. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured, reach
up through the flue opening and grab the attachment bar
and pull down inside flue opening (
Figure
5.5)
.
2. Insert the 5/16 bolts inside the cast flue and through
the chimney mounting bar. Securely tighten the nuts.
Fasteners are provided.
3. Re-install the tube channel assembly, baffle board,
ceramic blanket and baffle protection channel.
NOTE:
These are generic drawings and may not represent
your specific model.
