16
Vermont Castings Madison
Attach the Chimney Connector
Insert the crimped end of the first section of chimney
connector into the flue collar. Using the holes in the
collar as guides, drill 1/8" (3mm) holes through the
connector pipe. Use the three #10 x 1/2" sheet metal
screws provided to secure the chimney connection to
the flue collar.
If applicable, attach Chimney Connector Heat Shields
following the instructions included with those parts.
Install the Outside Air Adaptor
The optional #1891 Outside Air Adaptor provides a
collar to which a 3 inch diameter air duct may be
attached directly to the air inlet area at the back of the
stove. This option can be installed in two different
configurations, with Rear Heat Shield #1893 and
without the heat shield.
With Rear Heat Shield
1. Engage the Adaptor against the Air inlet opening in
the Rear Heat Shield. Align clearance holes in the
adaptor with pilot holes in the Rear Heat Shield as
shown at the bottom of Figure 26.
2. Use two sheet metal screws provided in the kit to
attach the Adaptor to the Rear Heat Shield at the
aligned holes.
Without Rear Heat Shield
1. Facing the rear of the stove, loosen the pan head
screw located a the upper left hand corner of the
primary air inlet two revolutions. Position the
Adaptor over the air inlet opening in the rear of the
stove with the pan head screw passing through the
slotted tab in the Standoff. Make certain that the
damper tab is located between the stove and the
standoff and is oriented as it was before the screw
was loosened. Tighten the pan head screw using
the access hole in the standoff. The Thermostat and
Primary Air Flap should operate freely.
2. Engage the Adaptor against the air inlet opening in
the Outside Air Standoff. Align clearance holes in
the adaptor with pilot holes in the Standoff as
shown at the top of Figure 26.
3. Use two sheet metal screws provided in the kit to
attach the Adaptor to the Outside Air Standoff at the
aligned holes.
Stove Back
Outside Air
Standoff
Outside Air
Adaptor
Primary Air Flap
Rear Heat Shield
Oustide Air Adpator
ST462
Fig. 26 Outside Air Adaptor options.
Without Rear Heat
Shield
With Rear Heat Shield
Summary of Contents for Madison 1655
Page 26: ...26 Vermont Castings Madison...
