Vermont Castings • Apsen C3 Installation Manual_R2 • 2019 - ___ • 07/19
18
8390-950i
A. Removing Unit from Skid
1. Inspect the stove and contents for shipping damage
or missing parts. Immediately notify your dealer of any
damage. Do not install this stove if any damage is evident
or any parts are missing.
2. Remove (4) 5/16 X 2” lag screws from shipping brackets.
B. Install Stove Legs
Leg installation will be accomplished most easily with the
help of an assistant who can tilt the stove onto its side while
you attach the legs.
1. With your assistant holding the stove up on its side,
remove (2) shipping brackets by removing the 3/8” Hex
bolts and washer
s.
Note: DO NOT
discard these bolts
and washers as they will be re-used to install the legs.
2. Place legs at each corner of the unit and install the 3/8” hex
head bolts and washer previously removed. The shoulder
of the legs should seat within the locator bosses cast into
the stove bottom at each corner, Figure 5.1. Tighten the
bolts with the wrench.
CAUTION: Overtighening can
strip tapped threads.
3. With your assistant, lift the stove up onto its legs and hold
it in a tilted position to install the remaining two legs with
hex bolts and washers.
5
Appliance Set-Up
Carefully tilt the stove on the
shipping brackets to install one
front and one rear leg.
Then tilt the stove up on those
legs to install the remaining two.
Figure 5.1
- Install legs on one side of stove then the other.
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating with the front doors open.
• Operating appliance without legs attached (if supplied
with appliance).
• Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
WARNING
!
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult insurance carrier, local building, fire officials
or authorities having jurisdiction about restrictions,
installation inspection, and permits.
CAUTION
!
Adjust the Leg Levelers
Lift the stove slightly so there is no weight on the leg while
making the adjustment.
