Vermeer S925TX, Operator'S Manual

Page: 89 / 104

S925TX Mini Skid Steer Operating the Machine 50-11
Backfilling with the Bucket
Step 1: Fully lower lift arms.
Step 2: Use Lift / Tilt Controls to tilt bucket forward until cutting edge of bucket contacts the ground.
Step 3: Move machine forward to the edge of the hole or trench to push material into it.
Step 4: Tilt bucket forward as soon as cutting edge is over the rim of the hole or trench to dump material out
of the bucket.
Step 5: If necessary, raise lift arms and tilt bucket forward to empty the bucket.
O
PERATING WITH
O
THER
V
ERMEER
-A
UTHORIZED
A
TTACHMENTS
Refer to the attachment manual supplied by the attachment manufacturer for operating and maintenance
instructions for the attachment and additional instructions that may be required for the S925TX.
WARNING: The weight of your machine may cause the ground to give way. Machine can
fall and tip over. Death or serious injury could result. Keep well away from cliff edges.
Take care when backfilling. Do not go too close to edges. Do not drive or operate on
unstable ground.