Vermeer S925TX, Operator'S Manual

Page: 23 / 104

S925TX Mini Skid Steer Welding Precautions 11-1
Section 11: Welding Precautions
W
ELDING
A
LERT
- E
LECTRONIC
C
OMPONENTS
NOTICE: Electronic modules and controllers will be damaged from stray voltages and
currents generated during welding if not unplugged before welding .
To prevent extensive and costly damage to electrical components:
Step 1: Follow Shutdown Procedure , page 23-1.
Step 2: Disconnect battery cables.
Step 3: Disconnect wire harness ( 1 ) from engine ECU (gas option
only).
NOTICE: Disconnecting the battery cables will not prevent damage to
electronic components during welding. Each of the controllers must have
the electrical connector unplugged from the module.
• Clamp welding ground as close to welding location as possible. Do
not allow welding current to pass through a bearing or other joints
of moving components.
• Do not connect welding ground to any electrical component or
controller.
• Protect wiring and wire harness from weld spatter and debris.
• Use proper welding procedures.
NOTICE: Before welding, clean all grease, dirt, oil, moisture, or any other foreign
material. Sand paint from the area to be welded.
1