Vermeer McLaughlin V25, Operator And Maintenance Manual

Page: 57 / 182

V25/VX30G/VSK25/VSK30G Vacuum Excavators Transporting the Machine 30-7
Pintle Ring - Attach
Step 1: Pull up on release lever and pull back latch assembly (1) to open.
Step 2: Place pintle ring over the hitch.
Step 3: Push latch assembly forward and down until release lever is in
locked position.
Step 4: Install keeper pin (2) .
Safety Chain/Electrical Connector/Breakaway Cable - Attach
Step 1: Cross safety chains (3) under the tongue and attach them to the
towing vehicle.
Keep chains as short as possible, but leave enough slack to turn
corners.
Step 2: Attach electrical connector (4) to the towing vehicle. Check that
highway lights and electric brakes are functioning properly.
Step 3: Attach breakaway cable (5) to the towing vehicle bumper or frame. Leave sufficient slack to allow for
turning radius of the trailer.
NOTICE: Adjust breakaway cable length so the breakaway system applies the brakes only after both the hitch
and safety towing chains have disconnected. The breakaway system is not to be used as a park brake.
Step 4: Remove and stow wheel chocks.
2
1
3
5
4