1.
First test the brake without any load.
2.
Then test the brake with a dynamic test load of 110% (EUR) or 125% (US) of the rated
capacity. Size of the dynamic test load depends on the country regulations.
3.
In the European countries, test the brake also with a static test load of 125% of the
rated capacity.
7.4.6
Replacing the double brake
1. If a load is attached to the hook, remove it.
2. Disconnect the chain hoist from the main power supply network.
3. Remove the end cover on the motor side.
For more information, see chapter Removing and installing the hoist covers.
4. Pull out the control board.
5. When the control board is a few
centimeters out, unplug the brake cables
(1) and (2) from the control board.
1. Main brake
2. Secondary brake
6. Remove the end cover on the brake side.
For more information, see chapter
Removing and installing the hoist covers.
7 MAINTENANCE
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
6/2020
