6
Enter the following command if you want to add a new user to access the IPMI
sub-system. Note that this is an optional step.
IPMI User Add <
User_Name
>
At the
New Password
prompt, enter a password for the user.
The default user name is
sysadmin
. The default password is
P@ssw0rd
,
where
0
is the number zero.
At any point in time, you can run the following command to view the users who
can access the IPMI:
IPMI User List
7
Type
Return
to return to the
Main_Menu
prompt.
8
Use a Cat5 or a Cat6 cable to connect the remote management port to the
network.
9
Make sure you can reach the Veritas Remote Management Console over the
network by using the new address in a web browser.
10
The appliance is ready for initial configuration. See the
NetBackup Appliance
Initial Configuration Guide
for the appropriate platform for information about
initial configuration requirements and procedures.
Note:
Once the initial configuration has been completed, you can connect NIC1
(eth0) to an administrative network that does not provide any backup data
transfer.
Accessing and using the Veritas Remote
Management interface
The IPMI web interface is known as Veritas Remote Management interface. You
can use Veritas Remote Management interface to log on to the NetBackup Appliance
Shell Menu.
44
Verifying hardware operation and configuring IPMI
Accessing and using the Veritas Remote Management interface
