8
Proceed to the following section to connect power cords to the hardware.
See
on page 74.
Connecting NetBackup nodes to the network
This section provides information about connecting the network ports on both
compute nodes to your network. Network ports on the rear panel of the compute
node are shown in the following diagram.
■
Item 1 - IPMI (remote management) port
■
Item 2 - eth0/NIC1 port (for laptop connection)
■
The default IP address for this private network port is 192.168.229.233.
■
The default login credentials are:
User name:
admin
Password:
P@ssw0rd
■
Item 3 - eth1/NIC2 port
Each of these ports requires a Cat5 (minimum) Ethernet cable.
■
SSH
■
Veritas Remote Management Console (virtual KVM)
■
Physical keyboard and monitor
The common tasks that you can perform in the appliance shell menu include:
■
Initial configuration
■
Network configuration
■
Appliance management
Veritas recommends using the IPMI port to establish remote access to the appliance.
72
Hardware installation procedures
Connecting NetBackup nodes to the network
