■
The release latch clicks into place.
■
Repeat the process for each carrier in the bottom drawer of the shelf.
7
Verify that all disks are properly seated in the slots.
8
Slide the bottom drawer into the storage shelf. Press the two drawer release
buttons located (one per side) on the side of the drawer to close the drawer
until the latches click.
9
Engage the anti-tamper locks on the top drawer as needed.
10
Pull the top drawer forward as far as possible without damaging the hardware.
11
Install the disk drive carriers into the top storage shelf drawer.
12
Slide the top drawer into the shelf by pressing the two drawer release buttons
located (one per side) on the side of the drawer to close the drawer until the
latches click.
13
Engage the anti-tamper locks as needed.
Installing disk drives and blanks into a
half-capacity storage shelf
The Primary Storage Shelf and the Expansion Storage Shelf use 4-TB or 8-TB disk
drives. You cannot mix the two disk storage capacities in one shelf. You can have
different capacities in separate shelves.
This section provides instructions for installing disk drives into a storage shelf that
has one half of the total usable storage capacity. Blank carriers are installed into
the slots that are not filled with disks.
Detailed maps of the slots are provided for the blanks and the disks.
43
Hardware installation procedures
Installing disk drives and blanks into a half-capacity storage shelf
