VERITAS 5250, Hardware Installation Manual

Page: 15 / 151

Table 1-4
Power button LED states
Description LED Power Mode State
The system power is off, and the
BIOS has not initialized the chipset. Off Non-ACPI Power - off
The system power is on and the
green Power button LED is active. On Non-ACPI Power - on
The system and the operating
system are up and running. Steady on ACPI
(Advanced
Configuration and
Power Interface)
S0
Mechanical is off and the operating
system has not saved any context
to the hard disk drive. Off ACPI
(Advanced
Configuration and
Power Interface)
S5
Appliance rear panel
The rear panel of the appliance contains several default ports that are embedded.
Three PCIe riser assemblies support various configurations.
The three PCIe riser assemblies outlined red are numbered, 1, 2, and 3 from right
to left. Slots 1 through 8 are shown in the risers.
The following list describes the numbered ports.
1. VGA port
2. 3 USB ports
3. IPMI, remote management, port
4. Four copper, RJ45, 1Gb Ethernet* ports, NIC1/eth0, NIC2/eth1, NIC3/eth2,
and NIC4/eth3, left to right
15 Hardware overview
Appliance rear panel