Note
When motion detection is set and saved, a motion activity window is
displayed. This motion activity window shows the motion level. The blue line is
the motion level and the red line is the motion threshold. This motion activity
window is useful to help motion detection settings (Detection level, Sensitivity
level, sampling pixel) based on your specific scene.
Configuring Network Failure Detection
Network Failure Detection allows the IP Camera to ping another IP device (e.g.
NVR, VSS, Video Server, etc.) within the network periodically and generates
some actions in case of network failure occurs, for instance, a Video Server is
somehow disconnected.
► To configure network failure detection
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click
System > Events > Network failure detection
.
4. Select
On
,
Off
or
By Schedule
.
If you select
By Schedule
, from the list, select the schedules to run.
5. From the
Detection Type
section, set the IP address to ping and the
interval.
6. From the
Triggered Action
section, select the alarm actions to perform.
Choose from the following:
Enable Alarm Output (low/high)
Send Message by FTP/E-Mail
7. Click
Save
.
Chapter 4: Advance Configuration
© 2014 Verint Systems Inc. All Rights Reserved Worldwide.
46
