6. In the
1st HTTP password
box, type the password.
7. In the
2nd HTTP server
box, type the name of the HTTP server.
8. In the
2nd HTTP user name
box, type the user name.
9. In the
2nd HTTP password
box, type the password.
10. Click
Save
.
Configuring Alarm Inputs
The camera comes with one alarm input and one relay output for
communicating with alarm systems to catch events.
► To configure alarm inputs
1. In a web browser, type the IP address of the IP camera in the Address bar,
and then press ENTER.
2. Type the username and password.
3. Click
System > Events > Alarm input
.
4. From the
Alarm Switch
list, select
On
,
Off
or
By Schedule
.
If you select
By Schedule
, from the list, select the schedules to run.
ON: System generates events based on the input state.
OFF: System will never generate events based on alarm input state.
Schedule: System will only generate events based on alarm input state
when schedule is ON.
5. From the
Alarm Type
list, select
Normal Open
or
Normal Close
.
Normal Close
: Events will not be generated when the alarm input is
closed. This is the normal situation. An alarm will be generated when the
alarm input will be opened.
Normal Open
: Events are generated when the alarm input is opened.
6. From the
Triggered Action
section, select the alarm actions to perform.
Choose from the following:
Enable Alarm Output
Send Message by FTP/E-Mail
IR cut filter (on/off)
Upload image by FTP
Upload image by E-Mail
Send HTTP notification
7. Click
Save
.
Chapter 4: Advance Configuration
© 2014 Verint Systems Inc. All Rights Reserved Worldwide.
44
