Verint Nextiva S1100, User Manual

Page: 57 / 107

Verint Video Intelligence Solutions 45
Nextiva S1100 User Guide
Reception timed-out. Retry attempt. The established connection has been broken. A
disconnected cable may be the cause.
Communication aborted. Max retries reached. The “Reception timed-out. Retry
attempt” problem is unresolved after the 10
th
attempt, so communication is aborted. Check
that the cable is not damaged and is properly installed. If the problem persists, contact
Verint Video Intelligence Solutions customer service.
Firmware upload in progress. The update process is in progress.
Firmware upload done. The update process has been completed successfully.
Invalid firmware file. Select a valid file. If the problem persists, contact Verint Video
Intelligence Solutions customer service to obtain a valid file.
Accessing the CLI of the Device
You may need to access the command line interface (CLI) of a device to perform
troubleshooting tasks. The CLI is hierarchically organized, with menus, sub-menus, and
individual options representing configuration parameters.
The S1100 device allows you to perform site surveys on your RF network. A site survey
scans all frequency channels, evaluate the interference level in each channel, and allows
you to choose the channel with the less interference. You can perform the following
operations relative to RF site surveys:
„
Specify the number of consecutive surveys to perform
„
Start and stop a site survey
„
Look at the last survey report
„
Reset the survey database
To access the CLI, you need a serial connection between the computer and the device.
To access the CLI of a device:
1. Connect the desired device to the computer using the CAB9P serial cable.
2. Start the Configuration Assistant.
3. Under the Unit Information pane, in the main Configuration Assistant window, click
Console.
The CLI of the device appears in the Console window.