Verint Nextiva S1100, User Manual

Page: 34 / 107

3: Configuring and Installing the Device
22 Verint Video Intelligence Solutions
6. Using the Configuration Assistant tool, perform a basic setup on the pair of devices (see
page 33).
†
Ensure that the repeater mode is disabled.
†
Enter the wireless passkey of the devices.
7. Connect the external antennas, monitor, and camera to the devices; ensure that RF and
video communication works properly in your wireless system.
The initial configuration is now complete for the two devices. You can now install them in
their final location (see page 23).
Configuring a Point-to-Point
Repeater
A point-to-point repeater is used as a range extender for wireless links, when you need a
device to retransmit the signals coming from one or many S1100 transmitters to their
corresponding receivers. The S3100-RP repeater is made up of two S3100 devices.
To configure a point-to-point repeater:
1. Configure the S1100 pair:
Warning: You must complete the configuration of the S1100 devices before powering
up an S3100 device.
a. In a lab, unpack the receiver and the transmitter and set them on a table.
Warning: To avoid material damages, you must never power any two devices while
their antennas are facing one another with a distance of less than 10 feet
(3 meters).
b. Unpack the two cable assemblies (CAB9P) and connect each one to the main
connector of a device.
c. On the receiver, connect the DB-9 plug at the other end of the CAB9P cable to a
COM port on your computer.
d. Power the receiver using the red and black wires of its CAB9P cable.
For a description of the boot sequence in a DFS context, see page 9.
e. When the boot sequence of the receiver is completed, power the transmitter using
the red and black wires of its cable.
Repeater Transmitters Receivers