Verilink WANsuite 6450, Reference Manual, Page: 138 / 205

4-30 W A N s u i t e 6 4 5 0
Figure 4.27 Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you press the “Esc” key and return to the
previous screen.
Interface Selecting one of the interfaces will bring up a screen where you can view
interface parameters. These screens are the same ones displayed when you
select a sub-menu from the Interfaces screen described earlier on page 4-7.
Type Selecting one of the services listed under the “Type” column will bring up a
screen where you can view (and, in some cases, change) parameters for each
type of service. The details displayed depend on the type of service currently
in effect. These screens are shown and described below according to each
type of service.
IP Service Details Screen
The IP Service Details screen (Figure 4.22), accessed by selecting “IP” from the
<Type> column in the IP Service screen, lets you configure the IP parameters
described on page 4-26.
To change any of the available parameters, you must enter new values in the
appropriate field(s) and press the “Esc” key to save your changes.
NOTICE:
To use newly established IP parameters, you must “Save and Restart.”
(See "Save and Restart" on page 4-6.)
ATM Service Details Screen
Access the ATM Service Details screen (Figure 4.28) by selecting the ATM
link under the Type column on the Services screen. The ATM Service Details
screen lets you access the configuration parameters described in the
paragraphs below.