4.7.2.4
Analysis Grids
The analysis grids are an integral part of the automatic analysis program and must be
set up before the test is started if the 'Auto Analysis' option is selected, see section
4.7.3.4 where automatic analysis is to be carried out after the furnace has finished its
test cycle. The grids must be adjusted so that they are central to the test piece and that
they completely cover the sample and its proposed deformation area.
Click the 'Analysis Grids' button to open this window.
Each test piece can be assigned a grid which is to be
overlaid over the test piece. The size and position of the
grid can be set here.
Note
: Right mouse clicking anywhere in the display window
will activate this box. Adjustment of the grids can be made
at any time prior to the analysis of the test pieces.
Identity
- this is the identity of the grid on the screen. The grid identified will be
highlighted in red and the grid identity number is shown on the top left corner of the
grid. When highlighted an individual grid can be adjusted.
Note
: The number of grids is controlled in the 'Test Piece Identification' screen, see
section 4.7.2.3.
Grid: Rows and Columns
- This changes the number of columns and rows of the
selected grid.
Grid: Size (Pixels)
- This changes the global pixel size of the individual grids. This has
no dimensional relationship.
Grid: Position X and Y
. The grid position on the screen can be specified. Grids can
also be positioned by using click and drag.
Grid Display
- Selecting the check box will display or hide the grids on the screen.
Select all Grids
- With this box selected all the grids shown on the screen can be
adjusted at the same time, except for the grid position.
33
Summary of Contents for CARBOLITE GERO CAF G5
