Verbos Electronics Multi-Envelope, Quick Manual

Page: 1 / 2

Envelope Generators
MULTI-ENVELOPE
The Multi-Envelope is divided into two envelope generators,
one at the top and one at the bottom. The “gate” and
“trigger” inputs on the left are where sources can be
plugged in to turn on the envelopes. A “trigger” simply
starts the envelope at the beginning and lets it run through
completely. A “gate” holds on the sustain stage as long as
it’s high. These inputs may be used together or separately
to get the re-trigger characteristic desired. The button is a
manual gate control.
While the envelope plays, multiple shapes are available at
the right. In the each envelope,
D elay A ttack D ecay s ustain
R elease, A ttack H old D ecay s ustain R elease, and D elay
A ttack H old R elease are available. The upper envelope
adds A ttack D ecay A ttack s ustain R elease (a unique echo
type envelope shape) and “stage outputs” which are gates
that go high while each stage is active. Both envelopes
have an “end pulse”, which is a 10ms trigger that goes high
when the envelope completes. The “end pulse” can be
patched to the “trigger” input to loop the envelope.
Shape and Time Control
The length of each stage is controlled by a red slider. The
sustain level is controlled by the black slider. External
voltages can be added to these controls via the jacks
below the sliders. The “shape” control changes the
envelope from linear ramps to RC type curves as it is
turned clockwise. Changing the “shape” will not significantly
change the length of the envelope.
Congratulations on obtaining your Verbos Electronics Multi-Envelope. This Euro-Rack format module provides two
independant 5 stage envelope generators that simultaneously put out multiple envelope shapes.
www.verboselectronics.com
Multi-Envelope