6
Operation & maintenance manual, Discfilter HSF2200-1/2F PFC
2. SAFETY INSTRUCTIONS
Hydrotech Disc filters in the HSF2200 series are designed for safe operation provided that they
are installed correctly and used in accordance with the enclosed instructions. The equipment
must be installed correctly and in accordance with local regulations. The equipment is designed
for use by one or more operators. You must read the relevant sections of this manual before using
the equipment or carrying out maintenance work.
⊲
Pay attention to all warning symbols that appear in this manual. Failure to do so may result in
serious personal injury and/or damage to the equipment.
⊲
Assume all electrical equipment to be live.
⊲
Assume all hoses and pipes to be pressurised.
⊲
The main power switch (see Figure 2.3) must be turned to OFF (0) and locked with a padlock
before maintenance work is performed.
⊲
Maintenance and service may only be performed by authorised personnel.
⊲
Adequate lighting should be used while operating the filter and when working in close prox-
imity to the filter.
2.1 Warning symbols
Warning symbols are used in this manual to draw attention to potentially dangerous situations:
Information that warns you of a potential risk of personal injury and/or damage to equip-
ment.
Warning stickers (see Figure 2.1) are affixed to the filter to warn personnel and act as reminders
to keep hands and fingers away from the filter’s moving parts.
2.2 CE marking
This equipment is CE marked (see Figure 2.2), which guarantees that the equipment is designed,
manufactured and described in accordance with the requirements set out in the EU Machinery
Directive.
2.3 Conversion
The CE marking does not include any components that are not approved by Hydrotech AB and
which are used in conversion/reconstruction of the equipment.
The warning symbols and CE marking must be attached where they are fully visible. If any part of
Figure 1
Figure 2.1
Figure 2.2