Venturer DM8721 Operating Instructions Download Page 1

of the sound is played. The lens on the disc table should be kept clean. Do not touch the lens or poke at it. If you

do so, the lens may be damaged and the unit will to operate properly.

On installation

Never install the unit where it would be subjected to:

 -

heat sources such as radiators or airducts.

 -

direct sunlight.

 -

excessive dust.

 -

moisture or rain.

 -

mechanical vibration or shock.

 -

unleveled surface.

Do not place any heavy object on top of the unit.

When the unit is used with an AC power adaptor, do not wrap the unit in a cloth, blanket, etc. If you do

so, the temperature inside and outside the unit may rise considerably, resulting in malfunctioning of the

unit or serious accidents.

If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture

may condense on the lens inside the unit. Should this occur, the unit will not operate. In this case,

remove the disc and leave the unit in a warm place for several hours until the moisture

evaporates.

For the unit to operate at its best, it should not be subjected to temperatures below 5

C (41

o

 F) or above

35

o

 C (95

o

 F).

Notes on headphones / earphone

Do not use headphones / earphone while driving, cycling, or operating any motorized vehicle, it may create  a

traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your headsets at high

volume while walking, especially at pedestrian crossings. You should exercise caution or discontinue use in

potentially hazardous situations.

Avoid using headphones / earphone at high volume. Hearing experts advise against continuous, loud and

extended play. If you experience a ringing in your ears, reduce volume or discontinue use.

Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to the

people around you.

If you have any questions or problems concerning your unit, please consult your nearest dealer.

PO

PO

PO

PO

POWER SOUR

WER SOUR

WER SOUR

WER SOUR

WER SOURCES

CES

CES

CES

CES

Using With Batteries

Insert two size AA batteries (LR6 or MN1500 alkaline) according to the “

 ” and “

 ” marks correctly

aligned.

Notes on batteries

• Insert batteries with correct polarity.

• Do not use old batteries together with new ones or different types of batteries together.

• If the electrolyte inside the battery should leak, wipe the contaminated parts in the battery

compartment with a cloth and replace the old batteries with new ones.

• When the unit is not to be used for a long period of time, remove the batteries.

• Do not mix old and new batteries.

• Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.

Notes on

 “ 

 ”

During playback (batteries are in use), “ 

 ” is off.

• When the battery voltage level is low,  “ 

 ” will flash for approx. 10 ~15 minutes, playback still continues

in this period.

• Playback would automatically come to a stop when the batteries have no more power.  Do not repeatedly

press “             ” as the unit may operate incorrectly. Replace all the batteries with new ones.

•  “

 ” would not be on if an AC adaptor is used.

Using on house current

If the unit you purchased does not include an AC power adaptor, please use a 6V 350mA AC power adaptor.

Plus pole “ 

 ” to the centre pin of the 3.5mm socket.

When the unit is not to be used, be sure to disconnect the AC power adaptor.

C

OMPACT 

D

ISC  

P

LAYER

Operating Instructions

Before operating the unit, please read this manual thoroughly and retain it for future reference.

CA

CA

CA

CA

CAUTION

UTION

UTION

UTION

UTION

The use of optical instruments with this product will increase eye hazard.

INFORMATION (For the customers in USA)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, If not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 -

Reorient or relocate the receiving antenna.

 -

Increase the separation between the equipment and receiver.

 -

Connect the equipment into an outlet that is on a circuit different from the one the receiver is connected.

 -

Consult the dealer or an experienced radio / TV technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your

authority to operate this equipment.

For the Customers in the United Kingdom and / European countries

This Compact Disc player is classified as a

CLASS 1 LASER product.

The CLASS LASER PRODUCT label is located

on the bottom exterior.

For the Customers in Canada

This apparatus complies with the Class B limits

for radio noise emissions set out in radio

interference regulations.

This product contains a low power laser device.

PRECAUTIONS

PRECAUTIONS

PRECAUTIONS

PRECAUTIONS

PRECAUTIONS

On safety

As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble the

casing. Refer servicing to qualified personnel only.

Do not put any foreign objects in the safety slot inside the disc compartment. If you do so, the laser beam may

come out when the lid is opened.

Do not put any foreign objects in the DC in 6V (external power input) jack. Should any solid objects or liquid fall

into the unit, disconnect the power supply and have the unit checked by qualified personnel before operating it

any further.

On operation

Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with high

fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of the disc with

no audio signals or very low level inputs. If you do so, the speakers may be damaged when the peak level

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT

EXPOSE THE UNIT TO RAIN OR MOISTURE.

TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE

CABINET.

REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

CAUTION

INVISIBLE LASER RADIATION

WHEN OPEN AND INTER.

LOCKS DEFEATED.

AVOID EXPOSURE TO BEAM.

FUNCTION OF CONTR

FUNCTION OF CONTR

FUNCTION OF CONTR

FUNCTION OF CONTR

FUNCTION OF CONTROLS

OLS

OLS

OLS

OLS

Opening the CD tray

to insert or remove a disc.

PLAY/PAUSE

Press            to begin play.

Press             during play to pause.

To release pause, press            again.

STOP 

Press once for disc playing stops.

Press twice for power off.

Track search and fast forward / fast reverse

SKIP

Press           lightly / repeatedly:

To locate the beginning of the

current selection or previous selections.

Keep          depressed:

To go back at high speed(search).

SKIP

Press           lightly / repeatedly:

To locate the beginning of next selection / selections.

Keep          depressed:

To go ahead at high speed (search).

PROG PROG (Program)

Playing the selections in the desired order.

PLAY MODE PLAY MODE

Button for selecting the various play mode.

Main socket

Phones jack

For connecting the headphones / earphones.

VOL ( Volume)

Adjust the volume.

Reviews: