Operation - 15
Jack Stand
The tiller is equipped with a jack stand to keep the
hitch arms positioned for reattachment when the tiller
is not in use.
Place the jack stand in the operating position (A) for
tilling or transport.
C
A
B
Place the jack stand in the storage position (B) prior
to detaching from the power unit.
The jack stand is spring loaded to keep it locked in
the selected position. To change the jack stand posi-
tion, pull out on the stand handle (C) and rotate to
the desired position.
Depth Gauge
The tiller is equipped with adjustable depth gauge
skid shoes to provide control of tilling depth.
To adjust the tilling depth:
1. Park the power unit on a level surface and engage
the parking brake.
2.
WARNING
When making adjustments with the tiller in the
raised position, the tiller must be supported with
blocks or stands. Hydraulic drift or accidental
release of hydraulic pressure could allow the tiller
to lower and trap a person or appendage, if the
tiller is not securely supported.
Raise the tiller and support securely with blocks or
stands.
3.
Shut off the power unit engine and remove the
ignition key.
4. Loosen the skid shoe adjustment bolts (A) slightly,
and move the front of the skid shoes up or down to
the desired position.
5.
A
Deeper
Shallower
Tighten the adjustment bolts to secure the skid
shoes, making sure both skid shoes are set to
the same position.
OPERATIONAL CONTROLS
