Rev 01/ page115 of 143
BATTERY
Open the battery cap 1
Remove the electrolyte cap
.
NOTE
After filling the electrolyte completely, use the removed
Cap
as the sealed caps of battery-filler holes.
Do not remove or pierce the sealed areas
of the
electrolyte container.
Insert the nozzles of the electrolyte container into the
Battery s electrolyte filler holes, holding the
container firmly so that it does not fall. Take
precaution not to allow any of the fluid to spill.
Make sure air bubbles are coming up each
electrolyte container, and leave in the position for
about more than 20 minutes.
NOTE:
If no air bubbles are coming up from a filter port, tap
the bottom of the two or three times.
Never remove the container from the battery.
Summary of Contents for zipr3i
