Rev 01/ page91 of 143
Driving face spring inspection:
Measure the free distance of the driven face spring. If the length
is shorter than the service limit, replace the spring with a new
one.
Service limit: 104.5mm (4.11 in)
Driven face pin and oil seal inspection:
Turn the driven face and check to see that the driven faces turn
smoothly. If any stickiness or hitches are found, visually inspect
the lip of oil seal, driven face sliding surface and sliding pins for
wear or damage.
Driven face inspection:
Inspect the belt-contacting surface of both
Driven faces for any scratches, wear and
Damage.
Replace driven face with a new one if
There is any abnormality.
Summary of Contents for zipr3i
