VENTO MOTORCYCLES
Rev no. 01/ Page 59 of 143
ENGINE REASSEMBLY:
Reassembly is generally performed in the reverse
order of disassembly, but there are a
number of reassembly steps that demand
detailed explanation. These steps will be taken
up for respective parts and components.
Oil seals:
Fit the oil seals into the crankcase following the
procedure below. Replace, removed oil seals
with new ones.
Apply special multipurpose grease to the lip of the oil seals.
Be sure to apply THREAD LOCK “1342” to outer surfaces
of right and left crankshaft oil seals to prevent
them from moving.
When fitting the oil seal into the crankcase, insert
it slowly with the special tools
.
NOTE:
Align the oil seal with edge
○
A
of the
crankcase as shown in the illustration.
BEARINGS:
Install the new bearings with a set of the
special tools.
Install the new bearing and oil seals into the
crank case cover with
Summary of Contents for Triton R4
