Ventilair Comair Aquacom, Manual, Page: 7 / 30

7
III User's manual
This section of the manual provides the
information to operate the Aquacom correctly,
what to do with an error and how to effectuate
maintenance.
NOTE: Always remove the plug from the
wall socket before servicing the unit!
3.1 Controlling the Aquacom
Aquacom is standard equipped with an Aquacom
digital operating panel which is integrated in the
front of the unit. The installer has installed the
operating panel on the correct side. The control
panel looks like the following figure.
The screen:
When the Aquacom is turned on, the time and
date will be shown on the screen. The next figure
shows the information which will be shown
standard. When the unit is turned off, ' - Unit off -'
will be shown.
Time Date
If an error occurs, an error message will be shown,
until the error is resolved. Check section five for
the necessary action. Even though the pump will
continue for most errors, it is important to repair
the error, since the unit does not operate like it is
meant and can be damaged in the process.
The basic control buttons:
The control panel contains four basic control
buttons:
This button is used to turn the
Aquacom on and off. When a power
failure occurs, Aquacom will restart in the same
mode in which it was before the power failure.
These buttons can be used to
select the sub- menus in the
main menu. In the different
sub- menus, the values can be
changed using these buttons.
This button is used to confirm your
choice in a (sub) menu.
The control panel will remain in the (sub) menu of
your choice until you change this yourself. The
display however will return to the standard view
after 20 seconds. Below, the menus for the end
user will be explained step by step.
Main menu:
Press
to get into the main menu. The main
menu provides access to the sub menus listed
below:
Use
and to select a sub menu. Use
to enter the menu. As long as a menu is not
confirmed, the value is shown which is currently
set.
Sub menu 1 – T1 outside
When this menu is selected in the main menu, the
current value is shown of the temperature of the
outside air, before this enters the heat exchanger.
This value cannot be changed, however this value
can be used when errors occur.
Sub menu 2 – T Aquacom
When this menu is selected in the main menu, the
current value is shown for the air temperature
after the heat exchanger. This value cannot be
changed.
1. T1 outside View outside temp.
2. T Aquacom View temperature after
heat exchanger
3. Time Set time
4. Date Set date
5. Pump test Test pump
6. P4 code Access installer menus
16:12 14.07.12